Constant-voltage LED strip feeder dimmable directly on 230Vac power line with home automation actuators phase-cut or phase-cut dimmer output with both Leading edge and Trailing edge technology in keystone, bottom-box and DIN-rail versions with knob, push-button, FM remote control and SMART APP Bluetooth, Bluetooth Mesh and WiFi controls. This feature makes it much more versatile than the dimmable versions with protocol signals because it does not need any other wires besides the two 230Vac power supply wires. Suitable for restoration installations where there is a lack of space to run other control wires besides the two 230Vac power supply wires. Thanks to these our POWER SUPPLIERS, any CV LED light fixture powered at constant voltage such as single-color LED STRIPs can be dimmed at will in the same way as traditional incandescent or halogen bulbs without having to change their electrical system connections. In push-button PUSH dimming in a single control of several units, no connections with additional synchronization wires are needed. Open circuit (OCP), short circuit (SCP), overload (OLP) and overtemperature (OTP) protections, self-resetting. Reference Standards: EN61347-1-2-13, EN6100-3-2-3, EN6100-4-2-3-4-5-6-8-11, EN61547.

The power supply is protected against short circuit, overvoltage, overload and abnormal temperature rise. When the protection trips, the power supply is interrupted, which will be automatically restored when the cause that caused the protection to trip ceases.

The power supply is only suitable for constant DC voltage LED STRIPs for which it is necessary to respect the polarity in the connection as shown in the diagram on the back. The device is for indoor use only (IP20 degree of protection) and can work at a temperature between -30° and +60°C. The maximum length of the cables supplying the LEDs must not exceed 2m to fall within the regulations imposed by CE marking.

In the direct control with Push Buttons of the Power Supplies, should the 230Vac supply voltage fail and return, it is programmed that the light of the connected LED STRIPs will turn on at maximum. To avoid this, either the Pushbutton Controlled Power Supply is installed interposed to the LED Dimmer from the bottom of the box (code TE7636 or TE7637) or a Switch I is installed in series with the 230Vac Power Supply Phase by means of which the power supply voltage is removed before being absent from the room for a long period.