Two-module flush-mounted control equipped with four buttons and two-color LEDs. The LEDs can be adjusted/excluded through the button on the control.

The device can drive a single actuator for single or double loads or two actuators for single or double loads independently of each other.

The device can be installed in a My Home system and use the physical or virtual configuration, or as a component of the Lighting Management system and use the specific configuration types (Plug&go, Push&Learn, Project&Download).

The device can be configured in two ways:

• PHYSICAL CONFIGURATION, by inserting the configurators into the appropriate slots.
• Configuration via MYHOME Suite software, which can be downloaded from www.homesystems-legrandgroup.com; this mode has the advantage of offering many more options than physical configuration
  
  

For the list of modes and their meanings, refer to the directions in this sheet and the "Function Descriptions" guide section within the MYHOME Suite software.

The device realizes the following functions:

• LIGHT CONTROL
• AUTOMATION CONTROL
• ACTIVATION OF PROGRAMMED SCENARIOS
• ACTIVATION OF PROGRAMMED SCENARIOS PLUS
  
  

The device if installed in a Lighting Management system can be configured in the following ways:

• Plug&go (see dedicated technical guide)
• Push&Learn
• Project&Download, with the Virtual Configurator software it is possible to realize all the functions listed below
• Dual light control
• Double CEN command
• Dual CEN PLUS command
• Dual AUX command