Dimmer Urmet Yokis MTV500E without neutral 5454052
UTD 5454052
3760054540521
Dimmer Urmet Yokis MTV500E without neutral, Works with any civil series control, Compatible with incandescent lamps and dichroic lamps with ferromagnetic or electronic transformer, Allows several buttons to be used in parallel (diverter circuit or with inverters), Soft start and soft stop functions for gentle switching on and off. Thanks to the possibility of reducing brightness, significant cost savings can be achieved.
€44.64
€44.64
Tax included
Tax included
Out of stock
Dimmer Urmet Yokis MTV500E without neutral, it Works with commands of any civil series, Compatible with incandescent lamps and dichroic lamps with a transformer ferromagnetic or electronic.
Allows the use of more buttons in parallel (circuit switch, or with the inverters), the Functions of Soft start and soft stop for a switched on and off sweet. Thanks to the possibility to reduce the brightness, enables a significant dollar savings. Keeping the button pressed, it is possible to vary the brightness from 3% to 100%, loads of from 5 to 500W.
Double memory: The last brightness level is stored to be recalled at the first pressure.
The lighting at 100% is easily callable with 2 short presses on the button. Built-in electronic protection in case of short circuit on the load, with automatic recovery after the fault is corrected. Increases the useful life of the light bulbs and the buttons, thanks to the Soft start. It also works with buttons with indicator light (max. 20) by adding a single accessory BV40 (cod. 5454071).
Features:
- Voltage 230V ~ (+10% - 15%) - 50Hz
- Power min. 5VA max. 500VA (300VA in boxes watertight)
- Max current 1.3 A / 2.2 A boxes watertight: 1-3 /300VA other boxes: 2.2 /500VA
FUNCTIONAL CHARACTERISTICS:
- The principle of change through disruption at the beginning or at the end of the phase by means of automatic recognition of the load type.
- The module has built-in MTV500E, it is 100% waterproof for external installations.
- Limitation of the inrush current through the pre-heating of the filament
- Built-in electronic protection in case of short circuit on the load, with automatic recovery after the fault is corrected.
- Electronic protection against overheating.
- Double thermal protection with the interruption of the power.
- Coil digital protected in case of long actuation of the button.
- Possibility of pilot 12 or 48VAC or DC with the addition of the accessory ADBT.
- Immunity to mains disturbances up to 1.5 kV.
There are no reviews
...
...